Install Guide

  • Open Roll
  • Closed Roll



1. Connect remote and hub

Remote:

Select a channel 1-15 you wish to pair your shade to by pressing + or - to change channels.

Press the button on the motor (a pen or screw helps) to enable pairing. Shade will beep.

Hold the middle (stop) button on the remote to pair. Shade will move slightly to confirm it is paired to that channel.


Hub/App:

Open the Automate Pulse 2 App. Follow the instructions to setup a new hub. You can either setup the shade with an already paired remote or directly to the hub.


2. Ready your brackets

Know what you are drilling into:

Your provided silver screws can drill into wood, drywall and plaster. Be sure to use anchors for drywall and plaster. The blue screws are for concrete and masonry and do not require anchors.  

Mark where your brackets will go:

Measure and mark the distance of the shade between your brackets. This is crucial especially if you are not going into a window frame and your brackets need to be the exact length apart of your shade.


3. Drill in brackets

The important part is to know what you are drilling into and use the correct screws.

Drill in the screws using a drill-bit extender for easier access. Ensure the brackets are facing each other as shown.

Important note: Hire a professional if you are uncomfortable using a drill.


4. Hang your shade

First, hang the motor end on the bracket that has the 2 prongs into one bracket. Then push the pinend side into the other bracket so it clicks into place and is now hung.

Now, add your silver bracket caps onto the brackets for a clean finish.


5. Set your shade limits

Test your shades direction. If moving the wrong way, then hold up and down at the same time. It will reverse direction.

Your shade won't move correctly until you set your future top and bottom positions for your new shade.

To set your top limit position: Move your shade to your desired top position by clicking up or down. Hold UP and STOP. Shade will beep. Your top position is set.

To set your bottom position: Move your shade down to your bottom position by holding the down button. Press stop when close to the bottom, then click the down button until you achieve your desired down position. Hold down and stop once you have reached your position. Shade will beep to confirm.

Shade exits pairing mode after these limits are set and you are ready to roll!